Da-Lite Designer Contour Electrol - Manual (Page 4)

4
Electrical Installation
Internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the
left end of the screen case.
Standard installation is for a single 120VAC or 240VAC wall switch to control the screen. Optional Control units may have been ordered.
Wiring diagrams for the built-in VPI and low voltage control are included in these instructions. Refer to additional instructions for the
external VPI, external low voltage control, SCB-100 and SCB-200. Refer to the appropriate wiring diagram for your screen.
Up
Up
Off
Off
Down
Down
This Switch Can Not
be used with LVC.
SPDT Switch with
Center Off
Rear or DPDT Switch
with Center Off
120V Wiring Diagram
For Standard
Wall Switch
240V Wiring Diagram
For Standard
Wall Switch
AC (Common)
AC HOT 120VAC 60HZ 1 AMP
Black/Yellow
Black
Black
Red
Whit
e
Black (Do
wn)
R
ed (Up)
Junction Box
Located In Left Endcap
Junction Box
Located In Left Endcap
Ground-Must Be Connected
To Building Ground
White
Black
Red
Green
Motor
NOTE: A single switch cannot be used to operate more
than one screen. Contact the factory for further information.
This Switch Can Not
be used with LVC.
Brown and Yellow AC HOT
220/240 VAC 50HZ 2 AMP.
Blue AC (Common)
Brown
BLUE JUMPER
WIRE
Blue Br
own (Do
wn)
Black (Up)
Blue
Brown
Black
Green
MOTOR
NOTE: A single switch cannot be used to operate more
than one screen. Contact the factory for further information.
Ground To Case
Ground To Case
Ground-Must Be Connected
To Building Ground