Da-Lite Designer Contour Electrol with Integrated Infrared Remote - Manual (Page 5)

5
Figure 4
Screen Adjustment
Hook
Case Cover
Screw
Figure 5
Rotate Up
Screen travel is stopped automatically in the down and up
positions by the limit switches that are preset at the factory.
If it’s necessary to adjust for more or less drop follow the steps
below. The case cover must be removed to access the motor
limit switches.
Remove the case cover screw from both ends of the screen.
See figure 4. Be sure to hold the cover while removing the
screws.
Rotate the cover up and away from the case until it can
be removed.
SETTING THE DOWN LIMIT POSITION
To Reduce Screen Drop: Turn the red limit switch screw
clockwise to decrease the amount of screen drop. Run the
screen down to test the stop position. If the screen drops too far,
raise the screen about one foot and adjust the limit switch again.
Repeat until the desired position is set.
To Increase Screen Drop: Turn the red limit switch screw
counterclockwise to increase the amount of screen drop. Run the
screen down to test the stop position. If the screen does not
drop enough, raise the screen about one foot and adjust the limit
switch again. Repeat until the desired position is set.
CAUTION: Do not adjust for more drop than what was
ordered. At least 1-1/2 wraps of fabric must remain on the
roller. This screen comes standard with 0" or 2" black at
top. See the specification data sheet for details.
ATTENTION! N'effectuez pas de réglage pour obtenir un
déroulement supérieur à celui commandé. Au moins 1 à 1/2
tour de toile doit être maintenu sur le cylindre. Cet écran est
doté de série d'une bande noire supérieure de 0 cm (0 po) ou
5 cm (2 po). Consultez la fiche technique pour plus de
renseignements.