Da-Lite Senior Electrol - Manual (Page 4)

4
Picture Surface Rolled Up Or Closed Position
Senior Electrol ® Instructions
NOTE: Adjustments should not be necessary to screen in the rolled up or closed position. If necessary, use the following procedures:
Picture Surface Rolls Too Far Into Case
1. Lower picture surface approximately two feet with operating
switch.
2. Place operating switch in “off” position.
3. Turn the “up” limit knob one-quarter turn clockwise.
4. Press operating switch to raise picture surface. Repeat operation
if picture surface continues to roll too far into case.
Picture Surface Does Not Roll Completely Into Case
1. Place operating switch in “up” position.
2. Turn the “up” limit knob one-quarter turn counterclockwise.
3. Test by lowering picture surface approximately two feet with
operating switch, then raise picture. Repeat operation if desired
position is not reached.
Raise Lower Raise Lower
Down Up
Side View End View
Bottom View
Outlet
Box
Suggested
Slot Width
Picture Surface
Wall Or Ceiling Type Hanger
3⁄4
3⁄4
3⁄4 3⁄4
3⁄4
2
3⁄4
Hinged Access Panel In Bottom (For All Wiring & Adjustments)
Length A = Fabric Width “B“
Plus 23" All Sizes NOTE: Install This Bracket
For Ceiling Type Hanger Only
10" Overall Width
Of Bracket
3⁄4" Diameter
Holes
3⁄8" Nut & Bolt
2"
2 7⁄8"
27⁄8"
2"
4"
3 3⁄4"
3⁄16"
7⁄8"
9 1⁄2"
3 3⁄4"
4 3⁄8
Figure 3
9 1⁄2 ± 1⁄4
“B“ 18 5⁄8
12 3⁄16
11 3⁄8 ± 1⁄16
“A“ ±1⁄4
8 ±1⁄4
12 3⁄16