Da-Lite Tensioned Large Advantage Electrol - Manual (Page 5)

5
1. Place operating switch in “down” position.
2. When the screen stops, turn the white “down” limit knob
(Figure 4) one-quarter turn counterclockwise. Test by raising
picture surface approximately two feet, then lower again. Repeat
until desired picture surface position is attained.
CAUTION: Do not adjust for more drop than what was
ordered. At least 1-1/2 wraps of fabric must remain on the
roller. This screen comes standard with 12" black at the top.
ATTENTION! N'effectuez pas de réglage pour obtenir un
déroulement supérieur à celui commandé. Au moins 1 à 1/2
tour de toile doit être maintenu sur le cylindre. Ce écran est
doté de série d'une bande noire supérieure de 30,5 cm (12 po).
1. Raise picture surface approximately two feet above
desired level.
2. Place operating switch in “off” position.
3. Turn the white “down” limit switch (Figure 4) one-quarter turn
clockwise. Test by raising picture surface approximately two
feet, then lower again. Repeat until desired picture surface
position is attained.
Caution: Adjusting the down limit switch for less drop by
more than 6” can cause the screen surface to lose proper
tensioning.
ATTENTION! Le fait d'ajouter ne déroulez pas trop l'écran
plus de 15 cm (6po) aux interrupteurs de fin de course peut
faire perdre la bonne tension à la surface de l'écran.
Screen Adjustment
More Screen Drop
Less Screen Drop
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite.
Should it be necessary to adjust for more or less drop of picture, proceed in the following manner:
NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments.
Figure 4
Screen Motor
LVC Control Box
Screen Motor
Limit Switches