Desa GA6052 - Manual

FIREPLACE HOOD
INSTALLATION INSTRUCTIONS
PART # GA6050 FLAT BLACK ENAMEL
PART # GA6052 POLISHED PLATED BRASS
PART # GA6053 ANTIQUE PLATED BRASS
Remove the contents of the fireplace hood kit.
Check for any missing or damaged parts. If any
parts are missing or damaged, promptly inform
the dealer where you bought this kit.
Fireplace Hood Kit Contents:
• 1-Fireplace Hood (consists of center-hood sec-
tion and two adjustable outer-hood sections)
• 4-Sheet Metal Screws
• 4-Masonry Screws
• 2-Mounting Brackets
NOTICE:
Read this entire instruction sheet before
installing the fireplace hood.
SIZING THE FIREPLACE HOOD
TO THE FIREPLACE OPENING OR
GLASS DOOR FRAME
The fireplace hood is adjustable from 28 to 48
inches. You must open hood wide enough to
cover the entire fireplace opening. You can open
hood wider if desired. For best appearance, make
sure center section of hood is centered with the
fireplace opening.
Follow the instructions below to properly size the
fireplace hood.
1. Measure width of fireplace opening or glass
door frame (see Measurement "A", Figure 1).
Use work space below to figure proper size for
fireplace hood.
Measurement "A" _______________
Subtract 24 inches
(width of hood center section) ___________
Subtotal = _______________
Divided by 2 _______________
Measurement "B" = _______________
Measurement "B" is the distance from the
outside edges of center-hood section to outside
edges of adjustable outer-hood sections (see
Figure 2). When adjustable outer sections are
extended to this measurement, hood will be
correct size. The overall width of the hood will
equal the width of the fireplace opening. If you
have glass doors and would like the hood to
hang beyond the edge of the door frame, add
1/2 inch to measurement "B". Make sure that
hood provides room for opening doors.
2. If hood is brass, remove all protective film
from brass.
3. Place center-hood section face down on a
smooth, soft surface.
4. Measure in from outside ends of adjustable
outer-hood sections. Place a piece of tape on
bent-under flange of adjustable outer-hood
sections to mark the distance of Measurement
"B" (see Figure 3).
Figure 2 - Measurement "B"
Figure 1 - Measurement "A"
Center-Hood
Section
Measurement “A”
Glass Door Frame
Measurement “A”
Fireplace Opening
Measurement "B"
Adjustable Outer-Hood
Sections
Tape
Measurement "B"
Figure 3 - Mark for Measurement "B"
Adjustable Outer-
Hood Section