Da-Lite Tensioned Large Dual Masking Electrol - Manual (Page 3)

3
Installation
Screen Adjustment
NOTE: Unit is not to be installed in air handling space.
Hangers (If required)
1. Make sure hangers are placed to fit into the
pre-determined notches.
2. Level unit lengthwise with a carpenter’s plum level.
CAUTION! Do not completely seal in unit. Access room must
be allowed for motor repair or fabric replacement.
ATTENTION! Ne fixez pas complètement l'unité. Un espace
doit être laissé pour pouvoir réparer le moteur ou remplacer
la toile.
3. Use supplied 1/8” nex key and a 5/16” wrench to remove silver
shipping brackets attached to slat and screen case (Fig. 3)
4. Remove wrapping paper and tape strips.
CAUTION! Do not cut wrapping paper or tape with knife
or any sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le papier d'emballage ou le
ruban adhésif avec un couteau ou un outil tranchant. Retirez
à la main.
5. Install electrical hook up that applies to your unit. Make sure
to review your Electrical Installation Checklists and wiring
diagrams (included) for either 110 volt switch, 220/240 volt
switch, or DRC low voltage control.
NOTE: Must be installed in accordance with the requirements
of the Local Building Codes, the Canadian Electrical Code
(CEC), CAN/CSA C22.1 and the National Electric Code (NEC),
NFPA 70. An appropriate disconnect device shall be provided
as part of the building installation.
6. Test installation by carefully running surface up and down
several times. Be prepared to stop screen. Standard Duty
Cycle: 1 MIN. ON / 10 MIN. OFF.
NOTE: The picture surface, when rolled down, should have at
least a full wrap and a half around the roller. Do not allow any
part of the roller to become exposed.
CAUTION! The mask should not be field adjusted for more or less drop.
ATTENTION! Le masque ne doit pas être ajusté sur place pour régler la chute.
Surface travel is stopped automatically in the fully opened and closed positions by limit switches
that are properly adjusted at Da-Lite.
CAUTION! Contact Da-Lite at 800-622-3737 or 574-267-8101 if screen motor needs adjustment.
ATTENTION: Contactez Da-Lite au 800-622-3737 ou au 574-267-8101 au cas le moteur de
l'écran a besoin d'être ajusté.
Figure 3
Slat Retainer
Brackets