Important parts of your da-lite screen, Setting up your screen, Closing the screen – Da-Lite Versatol User Manual

Page 2: Protect your screen

Advertising
background image

Figure 1 – Fingertip Tension Lock

A. Pull out the black spring

button and lower case.

B. Holding bottom tube,

raise exten-sion tube
until it locks in desired
position.

C. Press lightly down on

handle until surface is
taut and then lock by
pressing down on the
fingertip tension lock.

Handle

Fingertip
Tension
Lock

6

7

Important Parts Of Your Da-Lite Screen

Slat

Extension Tube

Screen

Case

End
Cap

Picture Surface

Push Button

Handle

Fingertip
Tension Lock

Roller

Black Spring Button

Tripod

Leg Shoes

Saddle

Gooseneck

Pull Bail

Slat Cap

Lift/Lower Tab

Setting Up Your Screen

1. Grasp screen handle with one

hand. Hold in vertical position with
tripod slightly above floor. Press
tripod lift/lower tab to extend
tripod legs. Set screen on floor.

2. Swing case into horizontal

position.

3. Lift picture surface by pull bail and

hook over gooseneck.

4. Release fingertip tension lock and

raise case (Figure 1).

5. Grasp extension tube firmly with

one hand. Press “Push” button
while raising extension tube–
extension tube will lock in first
position. Repeat until extension
tube is in desired position. Finger-
tip tension lock must be released
to permit extension tube to be
raised to highest position.

6. Press lightly down on handle until

surface is taut. Lock into position
by pressing down on fingertip
tension lock.

Closing The Screen

1. Lift fingertip tension lock to

release tension (Figure 1).

2. Grasp extension tube with one

hand. Grasp bottom tube with
other hand. Lift extension tube
slightly to release tension. Press
“Push” button with your thumb.
Lower extension tube slowly with
your hand allowing surface to re-
roll partially into case.

3. Lift pull bail from gooseneck and

slowly complete re-rolling picture
surface into case.

4. Raise or lower case until the black

spring button engages into hole in
bottom tube.

5. Swing case into vertical position.

6. Push gooseneck into opening on

case end cap until it locks.

7. Hold bottom tube with one hand

and place index finger of other
hand under lift tab on leg bracket.
Giving a slight lift to screen with
one hand, raise lift tab quickly with
other hand. Note that gooseneck
and extension tube are locked for
safe and comfortable carrying and
storage.

Protect Your Screen

Before re-rolling surface into case, examine both front and back of surface to be sure
they are free of foreign matter. A Zippered Carrying Case is also available as an
accessory through Da-Lite if needed.

Advertising