Da-Lite Netbook Charging and Storage Cart - Manual (Page 3)

3
2. Lay cart onto rear panel. See Figure 1. Install Plate Casters. Two
casters have wheel brakes and two casters have swivel locks.
Install both wheel brake casters on one end and both swivel lock
casters on the other end. It does not matter onto which end
either pair of casters is mounted. Tighten all fasteners.
4. Remove rear panel by turning the fasteners 1/4 turn in either
direction. Route the Power Cord through the shelves and out
through either side. See Figure 4. Install Cord Wind Bracket on
same side as the exiting Power Cord.
3. The Mats and some Dividers were installed at the factory. Install
the rest of the Dividers into cart. See Figure 2. Place the Dividers
into the slots marked for your desired configuration of cart. Slots
marked with a round hole are for holding 42 netbooks. Slots
marked with a rectangular hole are for holding 36 netbooks. Slots
without markings are for holding 33 netbooks. Store any left-over
Dividers according to Step 9. Install Divider by inserting top rear
portion of Divider first and then lowering front Divider tab into
shelf. It will be easiest to install the netbook charger as the Divider
is installed. See Figure 3.
5. The Circuit Breaker reset buttons and the output receptacles of
the power distribution device are shown. See Figure 5. The Extra
Receptacle is always powered as long as the ON/OFF switch is
ON and the cart is plugged into a powered receptacle. The Extra
Receptacle has a maximum rating of 1 ampere. It could be used
for a wireless router. If either one of the two Circuit Breaker reset
buttons are extended, push to reset the circuit breaker after it
cools down for 45 seconds. The fan is only on when charging
occurs in the cart.
Suggested Methods of Installation (Continued)
Figure 1
Figure 4
Figure 5
Figure 2
Figure 3
1
6
D
5
2
3
4
Power Cord
Bottom Shelf
Fan Circuit Breaker (1A)
Extra Circuit Breaker (1A)
Middle Shelf
Top Shelf
Extra
(Router)
Fan
B