Da-Lite Tablet Sync, Charging and Storage Carts - Manual (Page 3)

3
2. Lay cart onto rear panel. See Figure 1. Install Stem Casters. 4. Install the USB cords (supplied with the computer) for each tablet
computer. See Figure 3. Open each drawer. Insert the USB cord
into any available USB port on the Charging Board. Pass the
other end of the USB cord through the round Grommet at the
front of the drawer and let it hang just above the shelf. Wrap
excess cord around the Cord Cutouts.
3. Install Mats into cart. See Figure 2. Install Dividers into cart by
inserting the rear tab of the Divider through the slot in Partition.
Lower the Dividers’ bottom tab into the slot in the shelves.
Procedure (Continued)
Figure 3
Figure 2
USB Cord
Supplied With
Tablet
Cord
Cutouts
Open Port
On Charging
Board
Grommet
Figure 1
5
4
2
3