Da-Lite Da-Snap - Manual (Page 2)

2
1. Unpack the frame parts from the carton. DO NOT unroll the
screen surface at this time.
2. Slide the frame pieces together at corners. ( NOTE: Frame
assembly holes may not appear to fit properly at the corners
until all fasteners have been attached. Once fasteners are
attached, the frame corners will be drawn in for a proper fit.)
Secure frame pieces with #10 screws provided. Do not tighten
screws until all are started, then tighten. See Figure 1.
NOTE: The frame pieces are labeled “top” and “bottom”. Be
sure the frame pieces are assembled according to the labels.
This will ensure the snap pattern on the frame and screen
surface will match.
Figure 1. Rear View
Snap Stud
Side
#10 Black Screw
Side
Top
Bottom
Snap Stud
Frame Bracket
Quantities vary by screen size
Screens 80" and smaller viewing width = 3
Screens over 80" to 96" viewing width = 4
Screens over 96" viewing width = 6
Quantity Included ________________________________________________
Frame Assembly
Included Hardware
Large Wall Bracket (47" Long)
Installation screws not included
Quantities vary by screen size:
Screens 80" and smaller viewing width = 1
Screens over 80" to 96" viewing width = 2
Screens over 96" viewing width = 3
Quantity Included ___________________________
Small Wall Bracket (8" Long)
Installation screws not included
Quantity = 1. Only for screens 80" and smaller viewing width.
Quantity Included ___________________________
High Power® Frame Bracket
Screens with High Power® quantity = 2
Screens with 2-piece side frame rails quantity = 2
Quantity Included ___________________________
Snap Stud
Quantity Included
___________________________
#10 Screw
Quantity Included
___________________________
Use Installation Method Number
____________