Da-Lite Dual Format Imager - Manual (Page 6)

6
Wall Mounting Assembly
1. Depending on size of screen it will be shipped with either 2
wall brackets that are 48" long or 2 wall brackets that are 64"
long. Two small L brackets included will be used to hold
frame securley to wall at bottom.
2. To install the Dual Format lmager over a Da-Lite Perm-Wall
screen you will need to place the supplied wooden spacers
between the screen and the wall.
NOTE: Da-Snap, lmager and Cinema Contour frames do not
require any spacers.
3. Refer to Figure 9 hanger bracket location. Dimension A will
vary depending on the type of screen you have. Dimension A
is measured from the top of the screen frame to the top of
the hanger bracket.
4. Both wall brackets must be mounted into at least two wall
studs. Check to make sure both brackets are vertically level
with each other.
5. Drill holes and attach mounting brackets into wall. You will
need at least 4" clearance above the drilled holes to hang the
screen. Dimension for hole is shown from the top bracket to
center hole position. It is recommended to use a 1/4" x 1 1/2" lag
screw (not supplied) to fasten bracket to wall.
Screen Type Dimension A
Cinema Contour 3-3/4"
Perm-Wall 4-3/4"
lmager 4-3/4"
Da-Snap 5-1/4"
Figure 9
Figure 10
A
1 1/2"