Danby DPF074B1WDB - Manual (Page 8)

DOOR REVERSAL INSTRUCTIONS
Tilt the unit slightly towards the rear and prop it securely. Two 1
people are required to tilt the unit during the door reversal
process.
On the top of the unit, remove the 4 screw covers, then undo 2
the screws underneath.
180°
unscrew
Unscrew
Lift the top cover away from the fridge. 3
Remove the three screws. Then remove the upper hinge that 4
holds the door in place. Lift the door and place it on a padded
surface to prevent it from scratching.
Remove the bolt with a screwdriver and flip the hinge bracket. 5
Then re-attac h the bolt to the hinge bracket.
Take off the middle hinge by removing the screws. Then lift 6
the lower door and place it on a padded surface to prevent it
from scratching.
Move the hinge hole covers on the panel between the fridge 7
and freezer from the left side to the right side.
Remove the adjustable feet from both sides. Remove the 8
screws and the bottom hinge.
If you find the direction of opening the door on your appliance •
inconvenient, you can change it. Holes on the opposite side
have already been prepared in the factory.
6