Danby DTT100A1WDB - Manual (Page 11)

LAUNDRY METHOD WITH INTERMEDIATE SPIN
You can improve the rinsing effect and save
rinsing water by using an intermediate spin
between wash and rinse process:
1. WASH
• Operate the wash process as described in
wash procedure
2. Drain
• Drain the wash-tub by turning the drain valve
selection switch to DRAIN position
3. Intermediate Spin
• Move the laundry to the spin-tub
• Operate the spin process for about three
minutes as described in the spin procedure
4. Rinse
• Move the laundry to the wash-tub
• Operate the rinse process for about two to
three minutes
5. Intermediate spin
• Move the laundry to the spin-tub
• Operate the spin process for about three
minutes as described in the spin procedure
6. Overflow Rinse
• Move the laundry to the wash-tub
• Open the water tap
• Operate the rinse process for about two to
three minutes continuing water supply
7. Final spin
• Move the laundry to the spin-tub
• Operate the spin process
CLEANING AFTER USE
Cleaning after use will extend the life of your
washing machine. Before cleaning, shut off the
power switch and disconnect the power cord
from the electrical outlet, being sure to take
hold of the plug.
Cleaning the body
• Wipe with a soft cloth
• If extremely dirty, wipe with a cloth soaked in
a solution of water and dish detergent or
soap.
• Do not spray the washing machine with water
or use paint thinner, abrasive cleanser,
benzene, alcohol, etc., to clean it.
Cleaning the overflow strainer
• Remove the
filter frame by
pulling it
upward • Turn the filter
inside out and
wash the lint
off with water • Insert the
filter frame
into the center
agitator as it
was
• Remove
the strainer
by pulling it
forward • Wash off
the lint
stuck in the
strainer
during
overflow • Re-install
the strainer
1) Remove the drain
strainer from the bottom
of the tub using a sharp
tool such as a screw
driver
2) Wash off the lint stuck
in the strainer
3) Re-install the strainer
10
Cleaning the lint filter Cleaning the drain strainer