DaySequerra M4.2 TimeLock - Manual (Page 8)

8
M4.2Si TimeLock User Manual
Navigation
The M4.2 TimeLock™ employs a simple 3-button user interface. From the start ‘HomeScreen’ press
the center button once. An arrow will appear next to the frequency. Use the UP/DN arrow button to
toggle the Arrow on the LCD around the different fields on the HomeScreen. Press the Center button
to select a field to change. The arrow will start to flash indicating that the UP/DN arrows are available
to change the value of the field. Press the Center button to save and exit.
M4.2 TimeLock™ Operating Description - Controls and Indicators
Front Panel
Figure 1.
Status
• Alarms – illuminated red when an alarm is enabled and flashes red every second when an
alarm condition is active.
• HD Locked – Blue LED illuminates when tuner has acquired OFDM (orthogonal frequency
division multiplexing) portion of an HD RadioTM signal and digital carrier S/N > 58dB/Hz,
thereby permitting HD RadioTM digital audio to be valid. HD is displayed in upper right hand
corner of VFD when tuner has acquired OFDM portion of an HD RadioTM signal.
• Multicast – Blue LED illuminates when tuner has acquired OFDM of an HD RadioTM signal and
there is at least one multicast signal present.
• RF Level - Bi-colored LED: Green indicates strong RF > 40 dB. Red indicates weak RF < 40
dB.
• Up Arrow – Momentary push UP from the Homescreen will enter the Headphone volume menu.
Both arrows are used to increase and decrease the volume. From selection mode Press
ENTER again to change a value in any a field indicating a blinking arrow ready. Use the UP
and DOWN arrows to navigate/toggle through the available choices or range. UP Arrow button
tunes the frequency up one increment while tuning to a new station, when held for three
seconds it tunes faster at 1.5x speed. UP selects next stored preset station in PRESETS mode
(no faster mode, one push per preset). Selects next item in other menus and is used for other
functions as described herein. Holding the UP arrow while powering the unit on will restore
factory settings.
• Down Arrow – Momentary push DOWN from the Homescreen will enter the Headphone
volume menu. Both arrows are used to increase and decrease the volume. From selection
mode Press ENTER again to change a value in any a field indicating a blinking arrow ready.