Hd magnum series, Troubleshooting guide – Delavan M150 User Manual

Page 6

Advertising
background image

1228 Chestnut Avenue • Minneapolis, MN 55403

Delavan Ag Pumps

Document HD Magnum Install 3.15.06

HD Magnum Series

6

Troubleshooting Guide

Problem

Causes and Remedies

Pump Doesn’t Deliver Flow

Suction strainer is clogged

• Clean strainer

Loss of prime

• Make sure pump is below the liquid level

• Install anti-vortex fitting in tank

• Open vent line from the top-most plug on the pump volute to

bleed off air

• Check suction line for leaks

Collapsed suction hose

• Replace with wire reinforced hose

• Use larger diameter hose

Impeller clogged

• Remove volute casing and check for foreign material

Leakage Between Centrifugal Pump

Pump seal is leaking

and Hydraulic Motor

• Disassemble volute and impeller and replace seal

Hydraulic motor seal is leaking

• Remove from centrifugal pump and replace seal on the motor

Lack of Pressure from Centrifugal Pump

Insufficient Motor Speed

• Adjust hydraulic flow control

Make sure pump is fully primed

• See “Loss of prime” above

Check for clogged strainers

Excessive restriction on inlet hoses

• Use larger size hose, ball valves and strainers

Bypass screw is turned out too far (open center systems)

• Re-adjust bypass screw setting by turning it in

Cannot Reduce Spraying Pressure

Excessive motor speed

to Desired Range

• Adjust hydraulic oil flow to motor, using flow control

Motor on open center systems is too small

• Check selection guide for correct motor

Hydraulic Fluid Becomes Too Hot

Check hydraulic fluid levels

Check hydraulic filters and replace if clogged

Incorrect motor application

• Check selection guide for correct motor application

Check hydraulic hose sizes

• Hoses should be at least 1/2”

• Use 3/4” for hose runs over 15 ft. or flow

rates higher than 15 GPM

Check temperature with gauge

• Make sure temperature is 160° or less

Hydraulic Motor Operates Erratically

Liquid pressure varies

• Check for air leaks in inlet of pump

• Check for proper fluid levels in tractor

• Check for hydraulic motor wear

• Make sure tractor hydraulic system has clean filters

Advertising