Deltech Fitness DF908- Stack Loaded Lat Machine - Manual (Page 6)

ATTACH THE FOOT (N) TO THE BOTTOM FRAME (C) USING THE M10 x 76MM
BOLTS (FF), M10 WASHERS (II), AND M10 LOCKNUTS (JJ). INSTALL THE RUBBER
BOOTS (X) OVER THE ENDS OF THE FOOT. NOW INSERT THE 2” SQ. PLASTIC CAP
(S) AND 1 ¾” ROUND CAPS (W) INTO THE BOTTOM FRAME (C).
ASSEMBLE THE 4 ½” PULLEY (Y) INTO THE BOTTOM FRAME (C) USING THE M10 x
43MM BOLT (GG), M10 WASHERS (II), AND M10 LOCKNUT (JJ).
BOTTOM FRAME ASSEMBLY
TOOLS REQUIRED:
METRIC WRENCHES OR SOCKET SET
Some components may be pre-installed
from the factory
(NOTE: THE NUTS USED ON THIS
BENCH ARE LOCK NUTS, THIS MEANS
YOU MUST TIGHTEN THEM DOWN
PAST THE PLASTIC INSERT.)
JJ
FF
JJ
Y