DICE Electronics MediaBridge MB-1000 Toyota - Manual (Page 2)

Sirius Connect TM operation (on Satellite radio)
Firmware update
USB memory operation
USB iPod operation (SAT & CDC/MP3/MD emulation) AUX operation
USB iPod mode
PRESET/DISC1
change songs
SEEK•TRACK
PRESET/DISC2
change playlist
SEEK•TRACK
PRESET/DISC3
change artist
SEEK•TRACK
PRESET/DISC4
change album
SEEK•TRACK
PRESET/DISC5
change podcast
SEEK•TRACK
PRESET/DISC6
change audio book
SEEK•TRACK
PRESET/DISC1
change songs
SEEK•TRACK
PRESET/DISC2
change folder
SEEK•TRACK
PRESET/DISC3
change folder
SEEK•TRACK
PRESET/DISC4
change folder
SEEK•TRACK
PRESET/DISC5
change folder
SEEK•TRACK
PRESET/DISC6
change folder
SEEK•TRACK
Icon Legend
USB iPod mode
AUX mode
change volume setting
SEEK•TRACK
change bass setting
SEEK•TRACK
change mid EQ setting
SEEK•TRACK
change treble EQ setting
SEEK•TRACK
press button
press button
repeatedly
press & hold
button
• Select PRESET/DISC 1, then use the seek/track/tune buttons
to change from song to song.
• Select PRESET/DISC 2-6 to access Folders and use the
seek/track/tune buttons to navigate through the folders on your
USB flash drive.
• The Media Bridge unit will recognize the first 8 levels of
folders, with up to 200 accessible folders within each folder.
Only the first 1000 files will be read in each folder, the rest will
be ignored.
• Songs play in order of when they were added to the flash
drive.
• Use the RANDOM and REPEAT buttons on the radio/display
• Use PRESET 1-6 (DISC 1-6) to enter specific modes (SONG,
PLAYLIST, ARTIST, ALBUM, PODCAST and AUDIO BOOK).
• Within each mode, use the seek/track/tune buttons to browse the
items available
• Use RND/RPT buttons in CDC/MP3/MD modes and SCAN followed
by TRACK +/- and SCAN again to set random and repeat.
Note: if the iPod is unlocked for direct control, radio control will be
limited to Songs, Playlists, and Albums. Text display will also be
limited to show only current song information.
TIP: In CDC/MP3/MD emulation, selecting DISCS is done by using
the DISC +/- buttons.
Disconnect the Media Bridge module from the vehicle.
Download and install necessary software from www.diceelectronics.com
Open software to follow instructions for updating Media Bridge unit.
Plug in Media Bridge via mini USB cable and update.
Disconnect and reinstall the unit into the vehicle.
STEP 1:
STEP 2:
STEP 3:
STEP 4:
STEP 5:
• An auxiliary audio device can be connected to the Media Bridge
unit through the 1/8” mini-jack
• Audio device must be controlled manually.
• Audio level can be adjusted while in auxiliary mode by selecting
PRESET 1-4 (DISC 1-4) and using seek/track/tune buttons to
increase or decrease levels.
TIP: In CDC/MP3/MD emulation, selecting DISCS is done by using
the DISC +/- buttons.
• Stations can be saved to PRESET 1-6 by holding the desired PRESET button, while listening to the
station.
• TEXT button will toggle between the text fields.
• If a Sirius Connect compatible tuner is not detected, then either a “No Tuner” vehicle message is
displayed, or the SIRIUS option will not be selectable. Please refer to the factory manual of your radio
system about operating the Satellite mode.
• Go to Channel 000 to view the Sirius Tuner ID for activation. The 12 digit ID is displayed in two halves as
SID “123456-” followed by “-789ABC”.
Sirius mode in SAT radio
recall PRESET 1-6 stations store current station to PRESET 1-6 PRESET 1-6 PRESET 1-6 to store
station
Important disclaimer, please read!
Unauthorized reproduction or reverse engineering is strictly prohibited! Intellectual property included is distributed
under specific license agreement with respective owners and is licensed only, not sold. No warranty, explicit or
implied, is stated. Neither DICE Electronics, LLC., nor any of its agents, distributors, dealers or vendors shall be
liable for damages.
IN NO EVENT SHALL DICE ELECTRONICS' LIABILITY EXCEED THE PRICE PAID FOR THE PRODUCT
FROM DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM
THE USE OF THE PRODUCT, ITS ACCOMPANYING SOFTWARE OR ITS DOCUMENTATION.
Warranty and Support
Products carry a 90 day limited warranty that protects you from defects in material and workmanship of products
sold by DICE Electronics, or its authorized agents, distributors and dealers. The warranty period begins the day a
product is purchased by the end user. Products found to be defective during the warranty period will either be
repaired or replaced by DICE Electronics at no charge unless warranty is void. Unauthorized attempt of repair or
alteration of the product in any way immediately voids this warranty. Warranty does not extend to cosmetics or
finish. A DICE product specialist must determine that defect is present in the product and issue an RMA. Be sure
that all wiring is connected as described in the user manual and all related equipment is functioning properly.
DICE Electronics disclaims any liability for other incurred damages resulting from product defects. Any expenses
in the removal and reinstallation of products are not covered by this warranty.
If experience any problems or need help, please contact your local dealer or call 888-342-3999, or visit our
support site at http://www.diceelectronics.com/support.
Disclaimer and warranty Installation notes:
Troubleshooting
Problem Solution
Cannot select the interface.
Radio/ steering wheel controls do not
operate iPod.
Reset iPod and make sure the most recent iPod firmware is
installed. Check vehicle user manual on how steering wheel
controls work, long presses may toggle alternate function.
Why does the radio display show
“EMPTY/STOP” and no music plays?
End of a playlist or folder is reached. Please select a new
Playlist or Folder using Preset 2/DISC 2.
Check DIP switch settings. With the ignition OFF disconnect
vehicle harness from module for a few seconds and reconnect.
Verify that the correct button is used to access the interface.
On some cars the AM button is used to access SAT emulation.
Problem Solution
No audio from iPod source.
Reset the iPod. Verify proper connection to iPod/interface. Check
for compatibility. Older iPod models don’t support USB audio.
Music is distorted or sound level
is too low with iPod connected.
Make sure all EQ and BASS boost options are turned off on your iPod.
Sirius tuner can’t be selected.
Unit must be in SAT emulation. Check for proper connection to the
mini DIN 8 receptacle.
iPod does not charge.
Check all connections. See if iPod charges while connected to
computer or wall charger. You may need to reset the iPod.
SCAN scan channels FOLDER/CAT/TYPE change satellite category SEEK•TRACK change channel
Common Control
PRESET/DISC1
PRESET/DISC2
PRESET/DISC3
PRESET/DISC4
Why does category read
“PRESELCTD”?
Playback of content selected on the iPod before connected to
the interface continues until new content is selected.
Mini USB port for software update
Why is the interface not controlling
the iPod/USB drive?
Please make sure that the USB connection is not loose. Make sure
that an iPod case is not preventing the dock connector from being fully
seated. Disconnect and reconnect the device. If iPod is not responding
please try resetting it. USB device must also be FAT16/32 format and
contain supported MP3, WMA or AAC content.
10 11 12
13 14 15
16 17 18
Identify your audio system (refer to Installation tip section) first and set
switches accordingly. Note that your vehicle may support more than
one mode. Use the TEXT button on radio/display to toggle text fields.
Text is not displaying in selected
emulation.
Tip (Left audio) Ring (Right audio) Sleeve (Ground)
1/8” mini stereo jack (not included)
Installed by: Illustration:
Installed date:
Other notes:
What size of USB flash drive
should I use?
Large capacities are supported, however up to 4GB is
recommanded for optimal user experience.