Display Devices MFD-50 Microphone Table Lift User Manual
Page 5
Advertising
RevA
MFD-50 Lift Series Installation
6/7/2005
10.) Line up the top plate of the MFD with the cutout in the table. Once it’s aligned properly, attach the
unit to the underside of the table by threading four wood screws through the holes in the side flaps.
Exercise caution when attaching the screws so they don’t protrude through the top of the table. It
is recommended that you work with your mill worker while performing this step to insure a seamless
installation. If unit is not level see step # 7 to re-level.
Advertising