Display Devices ML-2011 Microphone Lifts User Manual
Page 7
7
Remote Control - Pin out
1 UP
2 DOWN
3 STOP
4 COMMON
5 12V trigger in
6 +5V out
1.)
Remove the j-box cover plate and connect AC power leads with wire nuts:
ground = green, neutral = white, hot = black.
2.)
Connect the hardwired hand-held remote control to the 5-pin Phoenix
connector in the center j-box.
3.)
Connect audio signal to the 3-pin XLR-f.
Three-button control – Contact Closure
‘Up’ button to pin 1
‘Down’ button pin 2
‘Stop’ button to pin 3
Common for all buttons to pin 4
Pin 5 & 6 are not used
Programming Show Position
Programming can only be done with the three-button control. If other methods of
triggering the lift are normally used, first program the lift with the remote and then
configure the lift for the other trigger method.
1.
Send lift to top position (‘Up’ button).
2.
Press and hold ‘Stop’ button for ten seconds.
3.
Press the ‘Down’ button. Lift will travel down. Press ‘Stop’ at the proper
show position. THIS MUST BE DONE IN ONE MOTION, DO NOT PRESS UP,
DOWN, OR STOP FOR FINE-TUNING OF POSITION.
4.
At proper position, press and hold the ‘Stop’ button for 10 seconds.
5.
Lift is now set. If you start the procedure and wish to quit after step 2, you
must reset power to the lift before normal operation will resume.