Dr. Brown's Deluxe Bottle Warmer - Manual (Page 7)

CAUTION: Before warming Dr. Brown’s ™ bottles in this appliance, always
remove all bottle components before warming to prevent the vent from
leaking fluid if gas forms during warming.
If leaking occurs during warming, pour out any remaining water in the
appliance’s heating chamber and reservoir, and refill the reservoir with
fresh water.
NOTE: To empty the heating chamber, unplug the product and remove the
reservoir from the side. With the cover open, tip the unit over a sink with the
reservoir opening facing up and drain any remaining fluid from inside the
heating chamber through the top opening.
2. Close the cover. Never use this appliance without the basket insert in place
and properly adjusted for the bottle or jar size.
CAUTION: DO NOT open the lid of the heating chamber once the heating cycle
has been started.
3. Press any button on the keypad (except O) to display the
“last time used”. If correct, press >. If you want to adjust
the time, press the up arrow button to increase the length
of time or the down arrow button to decrease the time.
NOTE: Pressing and holding an arrow button will cause
the timer display to change very fast. To change the timer
slowly, push and release the arrow button so the numbers
move incrementally. Once the display shows the desired
time, press start button. (SEE FIGURE 5)
4. When the heating cycle is complete the display will flash 00:00 for 60 seconds
and then shut off. At that time, there will be 5 audible beeps that indicate
the cycle time you selected is complete and the bottle or food is ready to be
removed from the appliance. You can open the top of the product at this point.
NOTE: You can turn the appliance off any time by
pressing the O button.
CAUTION: Be careful of the steam rising out from the
heating chamber. DO NOT put your hands on or around
the heating chamber during or immediately after the
heating cycle.
5. Grasp the side tabs of the basket and remove it
immediately to prevent residual heating. Place it on the
countertop and remove the bottle or jar. (SEE FIGURE 6)
6. Gently swish the fluid in the bottle around or stir the food thoroughly so the
temperature becomes uniform throughout the container.
7. ALWAYS TEST THE TEMPERATURE OF THE FLUID OR FOOD BEFORE
FEEDING YOUR BABY.
7
FIGURE 5
FIGURE 6