Dv Mark MULTIAMP MIDI PEDALBOARD - Manual (Page 4)

quIcK Setup
4
To start using the MULTIAMP MIDI PEDALBOARD, use a 5 pin MIDI connector.
Plug one end into the MIDI OUT jack of the MULTIAMP MIDI PEDALBOARD and plug the other end into the MIDI IN jack of the Multiamp (or
other MIDI receiving device). The Multiamp provides phantom power, so the pedalboard is directly powered; for other MIDI devices that don’t
provide that, you will need to use a 9V power supply connected to the DC IN.
Now assign the MULTIAMP MIDI PEDALBOARD’s MIDI
channel to the same MIDI channel of the Multiamp (or other
device that is receiving MIDI). Press the Menu button of
the pedalboard so that a “Chl” message will appear on the
display, now press OK and the MIDI channel number will
appear (by default both Multiamp and MULTIAMP MIDI
PEDALBOARD are setted on channel “00”); to change the
MIDI channel to match a receiving device’s MIDI channel
use the 8 and 4 buttons to scroll UP and DOWN “MIDI
Channels”, then press OK to store and ESC to return to
the program change (PC) function.
5 6 8 7
1 2 4 3
MIDI PEDALBOARD
CC0 CC1 CC2 CC3
CC4 CC5 CC6 CC7
HOLD 2 sec for 2nd FN
ESC OK MENU
PC/CC TUNER TAP
MULTIAMP
DC IN
9V
USB
MIDI OUT EXP PEDAL
5 6 8 7
1 2 4 3
MIDI PEDALBOARD
CC0 CC1 CC2 CC3
CC4 CC5 CC6 CC7
HOLD 2 sec for 2nd FN
ESC OK MENU
PC/CC TUNER TAP
MULTIAMP
DC IN
9V
USB
MIDI OUT EXP PEDAL