EarthQuake 6015V - Manual (Page 11)

11 Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
Operator’s Manual
6015 Series CRT Rototiller
ATTACH TINE SIDE SHIELDS
1. Locate side shields. SEE FIGURE 4
2. Take one side shield, raise it up against one side of the tine
guard and hold in place.
3. Place a 1/4” flat washer onto three 1/4-20 x 3/4” bolts. Insert
these three bolts in each of the three holes of the tine guard,
making sure they also pass through the side shield. Put an
additional 1/4” flat washers onto the underside of the bolts.
NOTE: The side shield needs to be below the tine hood when
they are attached together.
4. Hand tighten 1/4-20 nuts on each bolt.
5. Tighten 1/4-20 nuts on each of the three bolts connecting the
two side shields to the tine guard.
6. Repeat steps 2-4 for the second side shield.
FILL ENGINE CRANKCASE
1. Add oil according to engine manual. Do not overfill. Use a
clean, high quality detergent oil. Use no special additives with
recommended oils. Do not mix oil with gasoline. Oil level
must be full. Check the oil level by removing oil fill plug. Oil
level should be up to the bottom of the fill plug opening.
2. Always check oil level before starting engine. Refer to engine
manual for capacity and type of oil to use.
cover plate
transmission
gear case
dipstick
IMPORTANT
DO NOT PUT
ENGINE OIL IN
TRANSMISSION
LUBRICANT IS ALREADY
INSTALLED IN TRANSMISSION.
FIGURE 4
washers
& botls
side
shield
handle bar extensions