East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit - Manual (Page 90)

P/N: 4LGE020-010 v1.1, 2011-04-29
© 2011 Lysholm
All Rights Reserved, Intl. Copr. Secured
80
D. Fill the charge cooler system with a 75/25
water/antifreeze mixture through the top
opening on the surge tank. Fill slowly letting
air to purge out as the system is filled.
Reconnect the negative battery cable and
turn the key to the ON position (DO NOT
ATTEMPT TO START THE ENGINE). Make
sure that the water pump is operating and
that coolant is flowing through the surge tank.
Add coolant as needed. Check all fittings for
leaks. If the coolant is not flowing, remove
the charge cooler supply hose and lower until
coolant flows out of the hose. If necessary,
provide light suction to the hose to help prime
the pump. Verify coolant flow. Do not let the
pump run for more than 30 seconds without
coolant flow. Continue to check and fill the
system until the level stabilizes.
Fig 10E