Denon DN-A300M - Manual (Page 9)

ENGLISH
ENGLISH
6
Operation
Set the volume to the minimum by using
VOLUME .
1
2
Set <BASS> , <TREBLE> and
<BALANCE> to the center position.
Turn on the power by pressing <POWER>.
• The power indicator blinks red for several seconds, then
lights green.
3
Preparations prior to playing
Turning the Power Off
Using the microphone
Plug the microphone with 1/4" jack. 1
Set MIC MIX to " ON ".
• The MIC MIX indicator lights orange, then the mic input
can be mixed with the source input.
2
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
Use INPUT SELECTOR to select the source
to be played.
• Select one of the sources among the following: TAPE-2,
TAPE-1, PHONO, CD, TUNER and DVD/AUX.
• The input indicator for the selected source lights.
1
Play the selected source. 2
Adjust the volume by using VOLUME. 3
Adjust the tone with <BASS> , <TREBLE> ,
<BALANCE> and LOUDNESS.
4
Starting playback
Set AUTO MUSIC MUTE and MIC AGC
to " ON " or " OFF ".
• AUTO MUSIC MUTE can be setting the mute level.
(Page 3)
3
Adjust the mic level by using <MIC LEVEL> . 4
Use the microphone. 5
Starting recording
Use INPUT SELECTOR to select the source
(other than TAPE-1 or TAPE-2) to be recorded.
• When you select PHONO, CD, TUNER or DVD/AUX,
recording can be made on TAPE-1, TAPE-2 or both
simultaneously.
1
Set the device connected to the TAPE-1 (or
TAPE-2) terminal to the recorded mode. 2
Start playing the source to be recorded. 3
Press [POWER]
• The power indicator lights red and the power is set to the
standby mode.
• When in the standby mode, press [POWER] to turn the power
on.
Press <POWER>
• The power indicator turns off, and so does the power.
NOTE:
• Power continues to be supplied to some of the circuitry
even when the power is in the standby mode. When leaving
home for long periods of time or when traveling, either
press <POWER> to turn off the power, or unplug the power
cord from the power outlet.
NOTES:
• When not using the microphone, unplug it.
• DN-A300M does not have Phantom Power.
• It is recommended to use a microphone equipped with a
talk switch. Otherwise, the music source may be muted if a
trigger signal is output. Please turn AUTO MUSIC MUTE
button off when you do not use a microphone.