Elenco Snap Circuits SOUND &reg - Manual (Page 5)

How to Use Snap Circuits ®
Snap Circuits ® uses building blocks with snaps
to build the different electrical and electronic
circuits in the projects. Each block has a
function: there are switch blocks, light blocks,
battery blocks, different length wire blocks, etc.
These blocks are different colors and have
numbers on them so that you can easily
identify them. The blocks you will be using are
shown as color symbols with level numbers
next to them, allowing you to easily snap them
together to form a circuit.
For Example:
This is the switch block, which is green and has
the marking on it. The part symbols in this
booklet may not exactly match the appearance
of the actual parts, but will clearly identify them.
This is a wire block, which is blue and comes
in different wire lengths.
This one has the number , , , ,
or on it depending on the length of the wire
connection required.
There is also a 1-snap wire that is used as a
spacer or for interconnection between different
layers.
You need a power source to build each circuit.
This is labeled and requires two (2) 1.5V
“AA” batteries (not included).
A large clear plastic base grid is included with
this kit to help keep the circuit blocks properly
spaced. You will see evenly spaced posts that
the different blocks snap into. The base has
rows labeled A-G and columns labeled 1-10.
Next to each part in every circuit drawing is a
small number in black. This tells you which
level the component is placed at. Place all
parts on level 1 first, then all of the parts on
level 2, then all of the parts on level 3, etc.
Some circuits use the jumper wires to make
unusual connections. Just clip them to the
metal snaps or as indicated.
This set contains an egg LED attachment,
which can be mounted on the color LED (D8)
to enhance its light effects.
This set contains a sound energy
demonstration container, which will sometimes
be placed over the speaker. Its use is
explained in project 13.
To assemble it, lay the tube and flexible sheet
over the base, and then push the tube into the
base, as shown. Do not disassemble it except
to repair it. This set may include a spare for the
flexible sheet, and household plastic wrap also
works.
S2
2 3 4 5
6
B1
-4 -
Egg LED attachment
mounted to D8
Egg
Note: While building the projects, be careful not
to accidentally make a direct connection across
the battery holder (a “short circuit”), as this may
damage and/or quickly drain the batteries.
Sound Energy Demonstration
Container Assembly
(Adult supervision recommended)
Flexible
sheet
Base
Tube