Elenco Diode/Transistor Tester Kit - Manual (Page 7)

-6-
FINAL ASSEMBLY
r Peel the backing off of the front label and carefully
adhere it to the top case, aligning the holes while
doing so, as shown in Figure I.
r Install the push button switch to the top case in
the hole marked “TEST” as shown Figure J.
Fasten switch in place with the ¼” nut and
washer. Tighten the nut with pliers.
r Strip ¼” insulation off both ends of the red wire.
Insert one end into the hole marked “DIODE” on
the blue legend side of the PC board and solder
the wire into place. Tie a knot 2 ½” from the
soldered end of wire. Pull the free
end through the hole of the top case
marked “DIODE”, see Figure K.
r Strip ¼” insulation off both ends of
the black wire and insert one end
into hole “E” on the blue legend side
of the PC board and solder the wire
into place. Tie a knot 2 ½” from the
soldered end of the wire. Pull the
free end through the hole of the top
case marked “E”, see Figure K.
r Strip ¼” insulation off both ends of the yellow wire
and insert one end into hole “B” on the blue
legend side of the PC board and solder the wire
into place. Tie a knot 2 ½” from the soldered end
of the wire. Pull the free end through the hole of
the top case marked “B”, see Figure K.
r Strip ¼” insulation off both ends of the green wire
and insert one end into hole “C” on the blue
legend side of the PC board and solder wire into
place. Tie a knot 2 ½” from the soldered end of
wire. Pull the free end through the hole of the top
case marked “C”, see Figure K.
Figure K
Figure J
Figure I
Red wire
Green wire
Yellow wire
Black wire
Knots
Push button switch
Washer
¼” Nut
Top case