Elenco DataCom Tester Kit - Manual (Page 14)

ASSEMBLE THE FOLLOWING COMPONENTS TO THE PC BOARD
In all of the following steps the components must be installed on the top legend side of the PC board. The
board is turned to solder the component leads on the foil side.
R6 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
R3 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
R1 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
J2 - F-Connector
(see Figure K)
R4 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
R2 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
R7 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
U2 - 14-pin IC Socket
U2 - 74HC4066 IC
(see Figure E)
J1 - Modular Jack RJ-45
(see Figure L)
R5 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
R8 - 200Ω 5% 1/4W Resistor
(red-black-brown-gold)
(see Figure A)
U3 - 14-pin IC Socket
U3 - 74HC4066 IC
(see Figure E)
C4 - 470µF Electrolytic Radial
(see Figure G)
-13-
Figure K
Mount and solder the F-connector to the PC board in the
location shown. Note: The connector must be
soldered in straight.
Figure L
Mount and solder the modular jack to the PC board as
shown.