ENMET PPM Formaldemeter™ htV-m - Manual (Page 12)

Formaldemeter
htV-m
ENMET Corporation
10
5.5 Flow Chart
PPM Formaldemeter
htv-m
Press POWER , SAMPLE & CAL
▲ at the same to enter the menu.
Press SAMPLE to confirm your selection and to continue on to the next step. CAL
▲ & ▼ allow you to navigate and adjust
the settings.
Once option has been selected and you do not want to change any ore settings you may hold down the POWER button to
switch off. Your settings will have been saved.
Default Settings are Underlined.
Enter Configuration menu
ConF
Schy Schn
Schedule enable
▼
ALrS 0.10
Alarm duration in seconds
SoFy SoFn
Stop on Full memory
▼ ▼
ALrd 10
Alarm Duration in seconds
SbSy SbSn
Short between Samples
▼ ▼
ALrL ALrG
Alarm if ‘Lower than’ or Alarm if ‘Greater
than’ the setting
ALry ALrn
Alarm module enable
▼
S=t S=P S=A
Instrument Mode (Time, Peak or Area)
▼
Lt= 1 Lt-2 Lt=3 Lt=4
Clearing Limits
▼
PGtn
Do not change this setting.
▼
L 10.0 Area Integration (low)
H 60.0 Area Integration (high)
▼
1n=Y 1n=n
Inverted integration enable
▼
GtnY GtNt 3.5 GtnP
Do not change these settings.
▼
A2t=Y A2t=n
‘T Greater than A’ Gate enable
▼
Art=Y Art=n
‘Rising in Area’ Gate enable
▼
[ ]
End of Configuration menu.