0 installation – ENMET ENG – 97D STAND-ALONE User Manual
Page 6
ENG-97D S
TAND
-A
LONE
ENMET Corporation
4
3.0 Installation
3.1 Mounting Control
Open the cover and mount the instrument where desired as a
C
ONTROL
for the associated sensor/transmitter, using appropriate
mounting screws and the rubber seal washers supplied. See Precautions in introduction, regarding selection of the location.
See Figures 2 and 2A for mounting dimensions.
3.1.1
ENG-97D S
TAND
-A
LONE
in standard enclosure
Figure 2: Installation Diagram, Rear View
N
OTE
:
Allow at least 3 inches at the bottom of the closed enclosure for cable fittings and cable.
3.1.2
ENG-97D S
TAND
-A
LONE
in NEMA-4X enclosure
Figure 2A: Installation Diagram, Internal View
N
OTE
:
Allow at least 3 inches at the bottom and to the left of the closed enclosure for cable fittings and cable.