Eurocom T210C Convertible - Manual (Page 84)

Advanced Controls
3 - 14 Display Devices
3
To Enable Dual Display Clone Mode:
1. Plug the monitor into the appropriate port.
2. Go to the Intel(R) 82852/82855 GM/GME Graphics Controller Properties
control panel (see
“Intel Video Driver Controls” on page 3 - 8 ) and select
Devices (tab).
3. Click the Intel(R) Dual Display Clone icon in the devices tab (Note: this
option is only available when you have attached the monitor).
4. Choose which device is to be the Primary display, and which is to be
Secondary.
5. Adjust the settings by clicking the Device Settings (button) if necessary.
6. Click Apply > OK and close the control panels.
Figure 3 - 8
Device Settings
(Clone Mode)