Eurocom D700T Enigma - Manual (Page 64)

Power Management
3 - 8 Configuring the Power Button
3
Configuring the Power Button
The power button may be set to send the computer in to either Standby or Hi-
bernate mode (
Figure 3 - 3 ). In Standby mode, the LED will flash green.
In Hibernate mode the LED will be off. If you are in a power saving mode
set to save power through individual components (e.g. hard disk, monitor), the
LED will remain green.
Figure 3 - 3
Power Options
(Advanced - Power
Buttons)
(Sleep) Button

Sleep Button
You may also configure the Sleep/Resume key combination (Fn + F4) from the
menu illustrated in
Figure 3 - 3 . In Windows this is referred to as the Sleep button.
Power Button Sleep/Resume Lid