Eurocom M590K EMPEROR - Manual (Page 58)

Power Management
3 - 8 Configuring the Power Button
3
Configuring the Power Button
The power button may be set to send the computer in to either Stand by or Hiber-
nate mode. In Stand by mode, the LED
will blink green. In Hibernate mode
the LED will be off. If you are in a power saving mode set to save power through
individual components (e.g. hard disk, monitor), the LED will remain green.
Figure 3 - 3
Power Options
(Advanced - Power
Buttons)
(Sleep) Button

Sleep Button
You may also configure the Sleep/Resume key combination (Fn + F4) from the menu illus-
trated in
Figure 3 - 3 . In Windows this is referred to as the Sleep button.
Power Button Sleep/Resume Lid