EXFO MaxTester Series - Manual (Page 4)

P/N: 1065015 July, 2013 4/6
8. By holding the power meter by its faceplate, position it so that the
writings are right-side up.
9. Carefully align the power meter with the corresponding bay.
10. Gently slide the power meter into the bay until its faceplate is flush
with the edge of the bay.
11. Using a screwdriver, secure the power meter in place with all the
screws that you have removed at step 6.
12. Remove your antistatic strap.
13. Connect your unit to an external power source if desired.
14. If it is not already done, turn on your unit.
15. Start the power meter application to ensure that the instrument is
working properly.
Note: If the power meter is not detected, this could mean that it is not inserted
properly in the unit. In this case, repeat the installation procedure. If the
problem persists, contact EXFO.
Writings