EXFO BV10 Performance Endpoint Unit - Manual (Page 10)

Getting Started
6 BV10
Connecting the Power
3. Connect the other end of the wires to the DC power source.
4. To add a redundant DC power source on the BV10, repeat step 1
through step 3.
C
AUTION
The DC input feeds to the equipment must be protected by 20 A rated
maximum breaker provided as part of the building installation.
Permanently connected equipment must have a switch or
circuit-breaker for disconnection. If the switch is not part of the kit:

Include a switch or circuit-breaker in the installation.

The switch must be located easily, and placed near the equipment.

The switch must be specified as the disconnecting device for the
equipment.
W
ARNING
To avoid serious injuries as well as irreparable damages to your unit,
ALWAYS TURN OFF BOTH DISCONNECT DEVICES BEFORE OPENING OR
SERVICING THE UNIT.