Glow-worm Hideaway 70CF - Manual (Page 11)

11 221755A
SIDE CASINGS FITTING Diagram 5.2
1018
LOCATING
LUG AND
SLOT
No. 8
SCREW (2)
No. 8
SCREW (2)
CASING
BRACKET CASING
BRACKET
BOILER
PLINTH
5 Casing Location / Fitting
5.1 Side Vent Grille
One vent grille is supplied with the boiler which can be fitted at
the rear of the left or right hand side casing. The grille is fitted
on the opposite side to any pipework connections.
Fit the grille, if required, to the side panel as shown in diagram
5.1 prior to fixing the side panel. The plastic pegs are a tight fit
and are best pushed home with a flat faced tool.
Do not use the grille if water connections are on both sides of the
boiler or if the boiler is screened by fixtures.
5.2 Side Casings
Fit side casing by locating their lugs into the lower slots in the
base tray, see diagram 5.2.
Secure the casing sides to the casing bracket at the front top.
5.3 Top Casing
The top casing can be fitted in two alternative positions. that is,
with either the front edge flush with the door or overhanging it,
see diagram 5.3.
For a flush fitting top casing, fit four plastic pegs in holes “A” as
shown in diagram 5.3. For overhanging top casing, fit four
plastic pegs in holes “B”. The plastic pegs are a tight fit so they
are best pushed home with a flat faced tool.
Fit the top casing by engaging the pegs into the holes in the side
casings and then makes sure they are fully engaged by pushing
the pegs down.
SIDE VENT GRILLE Diagram 5.1
SIDE VENT GRILLE
(If required, will fit to
left or right side casing) PLASTIC PEG
SIDE CASING
(R.H. SHOWN)
0885
TOP CASING FITTING Diagram 5.3
1180
PEG POSITIONS IN TOP CASING
A = FRONT EDGE FLUSH
B = 10mm (
3 /
8
in) FRONT OVERHANG
TOP CASING PLASTIC PEG (4)
B
A
SIDE
CASING
(L.H.) A
B
SIDE
CASING SIDE
CASING
DOOR DOOR
AB AB AB AB