Glow-worm Ultracom2 cxi - Manual (Page 15)

0020085232_01 - 03/10 - Glow-worm - 13 -
ANY ASSISTANCE ?
Fault code Possible causes Solution
The
appliance
stops
working
Electrical circuit
interrupted
Check that there is no power cut and that the appliance is
correctly connected. When electrical power comes back
on, the appliance automatically comes back into service.
If the fault persists, contact your Installation/Servicing
company or Glow-worm Service.
Fault
Press on the "reset" button. Wait for 5 seconds. If the fault
persists and the symbol xx appears, contact your
Installation/Servicing company or Glow-worm Service.
Lack of water in the
installation
(< 0.5 bars)
Open the filling tap located under the appliance until
you obtain a pressure of between 0.8 and 1.2 bars on
the indicator, refer to diagram overleaf. If refilling needs
to be carried out too often, there may be a leak in your
installation. In this case, contact your Installation/Servicing
company or Glow-worm Service, to have your system
checked.
Excess water in the
installation
With central heating off, open the vent (bleed screw) on a
radiator to allow water to escape and reduce the pressure
in the heating circuit, or contact your Installation/Servicing
company or Glow-worm Service.
xx Fault
Contact your Installation/Servicing company or Glow-
worm Service.