Go Power! GP-REMOTE - Manual (Page 2)

Go Power! Remote
Owner’s Manual
2
1.0 Locking Remote
The GP-Remote can be used for the GP-1000, GP-1750 and GP-2500 inverters. It
features an LED indicator showing inverter status, on/ off switch and 25” cable that
simply plugs into the inverter.
1.1 Features
A: LED indicator
B: Push button
A
B
INVERTER ON
1.2 Indicator
Solid Green - Inverter “on”
No Colour - Inverter “off”
1.3 Functions
Short push (1 sec) - Inverter ON / OFF
2.0 Mounting a GP Remote
1. Cut out the template at right and position it on the wall where remote is to be
mounted.
2. Mark the location of the two holes, and the square area to be cut out. Note: Remote
switch assembly requires 3/4” (18mm) minimum clear panel depth.
3. Drill two holes, 1/8” (2.8mm) diameter and remove the cutout area.
4. Feed the phone jack connector and wire though the cutout hole in the panel and
route the wire to the inverter phone jack receptacle.
5. Position the remote switch assembly upright and secure to the panel using the two
screws provided. Plug the phone jack into the inverter. Press the button to turn the
inverter on and off.