Accessories 5.3 installing the cutter – GoDEX RT700i series User Manual
Page 60
56
5
Accessories
5.3 Installing the Cutter
053
The Overview of the Cutter
*
***
Remember to switch off the printer before installing the cutter.
**
**
Do not use to cut adhesive labels! Glue residue will be left on the cutter blade and impair its functioning. The
cutter has a blade life of 400,000 cuts when using paper liner which is 250μm thick and 3 inches wide.
***
*
You can cut paper with a max. width of 118mm.
****With the cutter installed, set the stop position in Qlabel to 30, and the E value to 30.
Preparation Steps
Please see the Section 5.1 Preparation Steps to complete the preparation steps before installing the cutter.
Installing the Cutter
1. Pass the connection cable through the slot of the printer.
COVER
CONNECTION CABLE OF CUTTER
FEED-OUT SLOT
SLOT