Installing the optional feet – GoldenEar SuperCenter Series User Manual

Page 5

Advertising
background image

GoldenEar Technology

SuperCenter Manual

Installing

the

Optional

Feet

If you are going to set your SuperCenter Speaker on a table or bookshelf that is below ear-level, (or on a shelf

above the TV that is above ear-level), you will want to install the optional adjustable leveling feet in order to
angle the speaker up (or down) towards the listeners. The SuperCenter is supplied with brass inserts designed
to go into the bottom of the speaker to hold adjustable feet to give you the option of angling the speaker.

Install the feet as follows:

Tools required:

Small Hammer (to tap in brass inserts)

Parts included:

Three threaded Brass Inserts

Three

Adjustable

rubber

leveling

feet

Instructions:

1. Carefully lay the SuperCenter on its top (bottom facing up) on a soft padded fl at object, such as

a table with a towel or blanket, taking care not to damage the speaker or grille.

2. There are four are pre-drilled holes on the bottom of the speaker under the grill cloth;

a. Locate the holes by feeling through the cloth (see fi gure below) — Two of the holes are

approximately 2" back from the front and about 12" apart (X) or 20" apart (XL);

b. There are two rear holes to choose from (see fi gure below) depending on the depth of the

surface you will place the SuperCenter speaker on and the desired angle. One is located

farther back than the other. Select one of these holes that best fi ts your installation;

3. Install the three Brass Inserts into the selected holes on the bottom of the speaker by gently tapping

the

inserts through the grill cloth with the hammer until fully seated against speaker’s bottom;

4. Insert leveling feet, place the speaker in its desired position and use the feet to angle and level

the

speaker as desired.

5

Advertising