GoldenEar SuperCinema 3D Array X and XL - Manual (Page 11)

11
Wall Mounting Instructions
If you are not comfortable performing the following mounting procedures we strongly suggest having a
professional wall mount your speakers (see your Dealer). Please note that hardware for the wall is not included
— make sure to use hardware appropriate for your wall type and the weight of the speaker being mounted.
Tools Required:
• Wall Mount Template (included)
• Pencil
• Level
• Drill (as needed, depending on hardware used)
• Screwdriver
• Appropriate Wall Mounting Hardware for the type of wall and weight of speaker, with #10 pan head
screw to fit the mounting keyhole on the back of the speaker
Instructions (after the speaker wires have been run and are in place):
1. Place Template in the desired location on the wall. Use the level to make sure the template is straight;
2. Use the pencil to mark the mounting screw locations indicated on the mounting template using the
holes in the template marked “Pilot Holes”;
3. Install your mounting hardware in this location, leaving 1 /
8
" (3mm) of space between the back of
the screw head and the wall.
4. Attach a wall mount pad to the four back corners of the speaker (see illustration below).
5. Carefully align the keyholes in the back of the SuperCinema 3D Array with the screws in the wall and
gently slide the speaker into place.
6. If the speaker does not slide in place, back the screws out a turn and try again; If the speaker is loose,
turn the screws in another turn and try again. Repeat as necessary.
NOTE: The threaded insert on the back panel is a 1 /
4
"–20 UNC x 0.5" (16mm) deep thread for use with various after
market mounting brackets as well as the included leveling feet.