Hall Research UHBX-3S - Manual (Page 11)

9
© Copyright 2014. Hall Research, Inc.
All rights reserved.
UHBX-3S
Next, select a firmware to program it into a desired HDBaseT output module. A desired
output module is selected by having its box checked. If all three modules are needed to
be programmed, all three boxes next to Outputs 1-3 must be checked.
Once, it is ready for program, just click the Program button.
NOTE: A remote programming will be in the future firmware update.
The HDBaseT Programmer will verify the
firmware in the module after it has been
programmed. A completed or failed status
will be shown.