Hall Research URA-232-XT - Manual (Page 15)

PC (VGA) & HD (YPbPr) AV with RS232 over Twisted-Pair Receivers
13
4. Software GUI
4.1 Overview
The URA-232 Programmer is a Windows™ GUI used to configure the unit’s discrete
input, serial parameters, and to upload or download user strings. Strings are sent
based on the state of a discrete input, a remote trigger from the sender or by a serial
command sent from compatible UVA232 Sender.
4.2 Getting Started
The URA-232 Programmer is recommended to run on PC with Windows XP or later.
The operating system should have all the latest updates and service packs installed.
The .NET Framework 2.0 or later is required prior to installing the URA-232
Programmer.
Most new PCs running with Windows™ XP or later version come with Microsoft™
.NET Framework 2.0 or later installed. If .NET Framework 2.0 or later is not installed
on your PC, you can install it from the folder called Framework 2.0 in the installation
software or download it from the Microsoft™ website.
After the URA-232 Programmer software has been installed, a program icon will
appear on the users desktop (as shown on the right) as well as under the
Programs\Hall Research menu.
Execute the URA-232 Programmer by double clicking the desktop icon or the
program menu selection found in the PC start menu.
The main screen is displayed as shown in figure 4-2
.
The URA-232 Programmer consists of three screens in tabular format,
Configuration, Settings and Communications.
Figure 4-1 FIGURE 4-2