Digi FASTPORT MIL-3200X - Manual (Page 19)

Chapter 3
MIL-3200X Series of FastPort Print Servers 3-3
M
I
C
R
O
M
O
D
U
L
E
S
• MIL-4340M: 10BASE5, with an AUI connector (version B)
• MIL-4350M: 10BASE-FL multi-mode, with an SMA
connector (versions A, B and C)
• MIL-4360M: Single-mode, half-duplex; with an ST
connector (versions A and B)
• MIL-4370M: Single-mode, half- and full-duplex; with an ST
connector (versions A and B)
Figure 3-1. MIL-4300M Micro Module
3.4 Installation
Do the following to install any of the following micro module:
1. Use a phillips head screwdriver to remove the screws
securing the faceplate of the base unit.
2. Remove the faceplate.
3. Make any configuration changes to the module.
4. Slide the module into the port.
UTP
16VAC PWR SYS NET LNK
MIL•4320M
CX PW
FT RX
FT
LK
RX
CX
Vacant Slot