User interface, 3user interface – Hanna Instruments HI 901 User Manual
Page 21
Advertising
3-3
USER INTERFACE
3
USER INTERFACE
3.1
Start Up
Once the instrument is assembled and installed, please follow these steps to start up the
titrator:
Connect the instrument to a main power plug with ground wire. Make sure that the
voltage of the main power and the one specified on the titrator are the same.
Turn on the titrator from the power switch located on the back of the instrument.
Wait until the titrator finishes the initialization process.
Press
when prompted or wait a few seconds for titrator to start.
Note: All the performed initialization processes must be successfully completed. If one of
them is terminated by a Failed message, restart the titrator from the power switch.
If the problem persists, contact your dealer.
Advertising