Hanna Instruments HI 8000 Series - Manual (Page 42)

42
5.7.4 START CONDITIONS – S 34
Time cond y Prog 07
Solar rad N
Ext tank: -- Link 02
START CONDITION S34
Using this panel we can set up how a particular program is triggered (started).
Multiple start conditions can be chosen for a program at the same time. In this
panel, a program can be set up to activate at a certain time, by the amount of
accumulated solar radiation, by the level of an external tank, or directly after the
completion of another program. The program number indexes this panel, which
displays and allows the setting of the following parameters:
Time cond
Time condition start. On keypad select Y for yes or N for no.
Program Number
Reflects the selected program (can be selected only inside panel C 03). See
Section 5.2.
Solar rad
Accumulated solar radiation start. On keypad select Y for yes or N for no.
Ext tank
By selecting external tank trigger, the start of the program is based on the
low level of an assigned external tank number.
Link
By selecting Link and entering a master program number, the start of the
program directly follows (linked to) the completion of another program.
5.7.5 SET START TIME – S 35
Prog 07
07:00 09:20 10:30
12:00 14:00 16:00
SET START TIME S35
If time is selected as the starting trigger for an indexed program, we can select up
to six different starting times within the daily scheduled limits (see panel S 31,
ACTIVE TIMETABLE). When the time start condition is not set on panel S 34 non
of the settings on this panel has effect. The program number indexes this panel
(for more details see Section 3.1 and Appendix 3). This panel displays and