Harmonic Resolution Systems SXR Audio Stand - Manual (Page 15)

Step 14. At this point the SXR Frame is completely assembled. Flip the SXR
Frame upright as shown in Photo 16. Move the frame to the exact final location for
use in your system. Make sure the front of the frame is the side with the HRS logo
on the Cross Brace facing into the room. You are now ready to level the SXR
frame. Place a level on the top Cross Brace. Rotate the Stand Point counter clock
wise (clock wise if viewed from the top of the stand) as required to level the stand
and make it stable (contact with floor at all four locations). Make sure you do not
rotate the Stand Points out more than 4-5 complete rotations. The Stand Points
must have 3 complete rotations of engagement remaining with the threaded strut
for proper performance and strength. If more adjustment is required use a shim
under the Stand Points so that the additional travel is achieved without violating
the 3 full thread minimum engagement requirement. When the stand frame is level,
hold the Stand Points with one hand and screw the Washer with your other hand
back into the top of the Stand Point and torque as much as possible with your
hands. You can use the Magic Grip if you need to get additional torque. This will
lock the Stand Points into place and take any motion out of threaded connection.
The result should be a very stable, firm, and level frame structure.
Photo 15