Hatteland Display 26 inch - HD 26T21 MMD (Widescreen, Touch Screen) - Manual (Page 59)

59 User Controls
IND100064-38
Color Mode Settings
Lets you adjust the color temperature (Kelvin degrees) of the image. This applies to the Main Source signal.
Window overlays (PIP/PBP) and the OSD Menu overlay will be unaffected. Lower values make the image
appear warmer, while higher values will make it appear cooler. The contents of these submenus are listed
below.
Illustration (does not appear in menu): The Kelvin color temperature scale (approximate and symbolic):
1800K 4000K 5500K 8000K 12000K 16000K
|---2---
Color Mode Settings - Color Temperature
Set to either “9300K” (Cool, a blueish white), “8000K” (Neutral, a white close to natural light),
“6500K” (Warn, a reddish white) or “User”, (only available when Full Menu is active).
|--------3--------
Color Mode Settings - Color Temperature - User
Allows individual adjustment of Red, Green and Blue color gains. The selected setting will
be preserved for each signal input (DVI/RGB/CVBS...)
● Note: Value adjustable from 0 to 100. 50 is factory default.
|---2---
Color Mode Settings - Gamma *Available in “Full Mode” only + Video Fullscreen
This will activate the stored gamma curve color compensation as well as the LED indicators or
backlight brilliance used with ECDIS. Set to either “No Calibration”, “Calibration VGA” or “Calibration
DVI”, where these represents the two storage locations for compensation data. When either of them
are active, they will override the color temperature setting for the signal channel. Different signal
channels can be set to different settings that will be preserved.
This function is suitable for use with external equipment. Color temperature will be disabled.
● Note: Default is No Calibration with Gamma 2.2 and 140nits.
OSD Menu Functions