HITEC P-51 Mustang - Manual (Page 8)

ASSEMBLY INSTRUCTIONS - F4U CORSAIR
Step 1: Landing Gear Assembly.
Slide the landing gear into the slot of the main wing mak-
ing sure they are in the correct position. Using a #0 Phillips
head screwdriver and the 2, 2.0 x 8 mm screws, secure the
landing gear to the wing.
Step 2: Attach the Main Wing.
Attach the main wing to the fuselage by sliding the tabs into
the front of the fuselage making sure to guide the servo leads
through the hole in center of the fuselage. Using a #1 Phillips
head screwdriver and the 4 x 35mm machine screw, secure the
wing to the fuselage.
STEP 1 STEP 2
Step 3: Attaching the Control Linkages.
Insert the elevator clevis into the outer-
most hole on the control horn and snap
the clevis closed.
STEP 4
Step 5: Attach the Guided Missiles (optional)
To attach the auxiliary guided missiles to the wings apply a small amount
of glue to the bottom bracket and position them in place on the wings.
STEP 5
Tools Required for Assembly
#0 and #1 Phillips Head Screwdrivers
Step 3: Assembly of the Tail Plane
a. Apply a small amount of glue to the
fuselage and tab on the horizontal sta-
bilizer then fi rmly attach the horizontal
stabilizer to the Fuselage.
b. Apply a small amount of glue to the
top vertical stabilizer making sure not to
get any glue around the rudder control
linkage.
c. Making sure the tail wheel is in the
neutral position slide the tabs of the
vertical stabilizer through the slot in the
top of the horizontal stabilizer as shown
in the picture.
STEP 3
- 8 -