HITEC Aurora 9X User Manual
Instruction manual
Advertising
Table of contents
Document Outline
- Section One - Introduction
- Table of Contents
- Steps for Successfully Programming the Aurora 9X
- What’s New?
- Aurora Transmitter Accessories
- Product Support
- System Component Specifications
- Glossary of Terms
- Icon Identification
- Safety Information
- Aurora 9X Transmitter Warnings
- Transmitter Battery Information
- Hitec 2.4GHz System
- Aurora 9X Transmitter Controls
- Touch Screen Lock
- The First Screen
- Home Screen Menu
- Section Two - Quick Start Guide to Set up a Simple Powered Airplane or Glider
- Section Three - Quick Start Guide to Setting Up a Simple Heli
- Section Four - System Menu
- Section Five Model Menu and More Special Hints
- Special Hints
- Model Menu and More - The Switch Selection Process
- Model Menu and More - Menu Functions Common to all ACRO, GLID and HELI models.
- EPA (End Point Adjustment)
- D/R & EXP (Dual Rates and Exponential Rates)
- Sub-Trim (Servo Sub-Trim Adjustment)
- Reverse (Servo Travel Direction Reverse)
- S. Speed (Servo Speed Adjustmemt)
- Monitor (Control Movement Monitor)
- T.Limit (Travel Limit)
- P. Mixes (Programmable Mix Menu)
- Gyro (on/off and Sensitivity Adjustment)
- Section Six - Model Menu-Common Model Functions to ACRO and GLID
- FLT.COND (ACRO)
- FLT.COND (GLID)
- FLT.COND (ACRO and GLID)
- Spoiler (GLID)
- SPO-ELE (GLID)
- AIL-RUD (ACRO and GLID)
- ELE-CAM (ACRO and GLID)
- RUD-AIL (ACRO and GLID)
- AIL DIFF (ACRO and GLID)
- AIL- FLP (ACRO and GLID)
- CAMBMIX (ACRO and GLID)
- FLP CON (ACRO and GLID)
- FLAPTRIM (ACRO)
- V.Tail (ACRO and GLID)
- AILEVATOR (ACRO and GLID)
- Elevon (ACRO and GLID)
- Thro.Cut (ACRO)
- T.Curve (ACRO)
- Idle Down (ACRO )
- B-fly (GLID)
- SnapRoll (ACRO)
- Knife Edge Mix(ARCO)
- Motor (GLID)
- Launch (GLID)
- Offset (GLID)
- Section Seven - Model Menu - HELI Specific Functions