Imaxrc B6-TWINS - Manual (Page 8)

These warnings and safety notes are particularly important. Please follow the instructions
For maximum safety; Otherwise the charger and the battery can be damaged or at worst it
can cause a fire.
WARNING AND SAFETY NOTES
WARNING AND SAFETY NOTES CHARGING OF THE Pb BATTERY
DISCHARGING OF THE Pb BATTERY
Never leave the charger unattended when it is connected to its power supply. If any
malfunction is found, TERMINATE THE PROCESS AT ONCE and refer to the operation
manual.
Keep the charger well away from dust, damp, rain, heat, direct sunshine and vibration.
Never drop it.
The allowable input voltage is 11-18V DC
This charger and the battery should be put on a heat-resistant, noninflammable and
nonconductive surface. Never place them on a car seat, carpet or similar. Keep all the
inflammable volatile materials away from operating area.
Make sure you know the specifications of the battery to be charged or discharged to
ensure it meets the requirements of this charger. If the program is set up incorrectly,
the battery and charger may be damaged. It can cause fire or explosion due to
overcharging. This warranty is not valid for any damage or subsequent damage
arising as a result of misuse of failure to observe the procedures outlined in this
manual.
CHARGING OF THE Pb BATTERY
Set up the charge current on the left and nominal voltage on the right.
Range of current is 0.1-5.0A, the voltage should match the battery
being charged. Press START/ENTER key for more than 3 seconds to
start charging.
The screen displays the real-time discharging status. Press
START/ENTER key to alter discharge current. Press START/ENTER
key again to store the parameter value you set. Press BATT
TYPE/STOP key to end the program.
Set up the charge current on the left and nominal voltage on the right.
Range of discharge current is 0.1-5.0A, the voltage should match the
battery being charged. Press START/ENTER key for more than 3
seconds to start charging.
The screen displays the real-time discharging status. Press
START/ENTER key to alter discharge current. Press START/ENTER
key again to store the parameter value you set. Press BATT
TYPE/STOP key to end the program.